Raised Battons For Tile Roofs

Elevated battens are typically used with tile roofs.

Raised battons for tile roofs.

Pressure treated option available with lifetime warranty. Battens elevate roof tile above the roof deck and can be run either horizontal or perpendicular to the slope of the roof. Wood battens rot over time because they do not allow air circulation under the roof tile. Slide a strip of batten under the tile so that the tile hangs from it and then fix the batten into place using a suitable hammer and nails.

On steep slopes tiles are usually fastened to the battens. The pads elevating the battens also seal around every batten fastener further waterproofing the system. Elevated batten system brochure. Cool roof system brochure.

High grade wood with 100 recycled pads to elevate above the roof deck to eliminate water ponding rotting of the battens and allow free flow of water and air. It also has the added benefit of keeping moisture off the roof deck. Blue roof batten for example signifies it s met the strength requirements of bs 5534 2003 a1. The space created by the elevated batten is a natural form of insulation.

Suitable for all tile profiles. Roof batten is made of wood and used to elevate roof tile off of the roof deck 4 ft. They allow air flow and prevent heat absorbed by the tiles to stay off the underlayment and keeps it from transferring into the attic below. Where the tile fasteners penetrate the battens and underlayment resulting in thousands of punctures on a typical roof.

According to cemtile most roof tile manufacturers allow direct nailing but on roofs with a slope greater than 7 12. For a relatively average house with a 1 500 square foot roof the total of underlayment and tiles will equal something approaching 8 tons in weight. Choose one of two types of protective treatments. Manufactures corrugated plastic battens for roofs.

A general rule is for the bottom edge of the tile to stop just short of the center of the gutter. If you are transitioning from a light roof to a tile roof the weight difference will be substantial. The fluted plastic battens solve many problems caused by the use of wood battens. On roofs with a steep slope tiles are usually fastened to battens.

Plastic battens can have up to double the penetrations per the instruction manual plastic battens are to be fastened every 6 with a staple fastener where as wood battens require a fastener every 12 wood battens are an approved anchor for tile hence a roof tile can be fastened to the batten alone and the nail used to hold down the tile does not have to penetrate the felt paper. Our most popular anti fungus anti mold purple. For example with a 6 inch wide gutter the tile would overhang by roughly 3 inches. Reduces labor and installation costs.