Prep A Garage Floor Without Using Acid

Even without hydrochloric acid.

Prep a garage floor without using acid.

Muriatic acid acts like liquid sandpaper by roughening the surface of the concrete. Without this process the epoxy will likely bubble or flake off. Required to correctly prep your garage floors for a great epoxy finish. How to prepare an old concrete garage floor for paint.

And is best used for concrete bases. A smooth concrete floor must be roughened before paint will stick to it. Acid etching is the process of applying hydrochloric muriatic or buffered phosphoric acid to a slab then rinsing it off with water. It also reduces the surface alkalinity of the concrete that can cause some paints to adhere poorly.

It is a blend of organic minerals surfactants and derivatives of a plant extract. The first is acid etching. Technically home and business owners can either use concrete grinding or acid etching to rough up. The standard for a tough good looking surface on the garage floor is garage floor epoxy.

You can brighten up your old garage floor with a paint job that will stand up to the wear and tear of garage use including car tire traffic. Depending on the type of product you are using for your concrete garage floor. Concrete floors however need to be treated with a process so that the epoxy adheres to the floor. First you need to apply the acid solution to your floor.

The concrete floor will fail if the coating doesn t bond mechanically to the concrete floor so the preparation is the most important part before applying any type of epoxy. So it is important that there is a solid bond between the concrete and epoxy coating so as not to end up with a failed epoxy garage floor. Although it is common to hear people refer to epoxy paint in reality epoxy and paint are different products with different chemical compositions. Epoxy creates a tougher coating than paint but it is a little trickier to apply.

This technique is the most d i y. For many years it was a standard method of concrete preparation used by nearly all industrial commercial and institutional floor coating installers depending on the floor size and system to be installed. For instance if you are using epoxy coating you can use it at full. Once it is spread out evenly use a scrubber a stiff bristle broom or a similar tool to work the acid solution.