Polyurethane Over Engineered Hardwood

You ll find it in.

Polyurethane over engineered hardwood.

Engineered wood flooring looks very similar on the surface but it is made from a relatively thin layer of hardwood bonded over a substrate of high quality plywood. Floors finished with aluminum oxide at the factory generally have a lifespan of 20 to 25 years compared to a ten year life of a floor finished with polyurethane after the floor is installed. The urethane used in sealing wood surfaces is more commonly known as polyurethane. The finish itself isn t anything special that i am aware of stained wood with a polyurethane coat over it.

Sweep up dust with a broom then vacuum clean the whole floor well. Lightly sand with a dull 120 to 150 grit abrasive screen or 2 steel wool under a heavy floor buffer. Oil based polyurethane has a slight amber or yellowish tint and can yellow even more over time which adds a bit of rich warm amber color to the floors if that s your goal. Polyurethane is recommended over varnish for hardwood floors.

Yes a polyurethane finished hardwood floor may have additional coats of polyurethane applied. Step by step step 1. I doubt a consumer could duplicate the process in a cost effective manner. Use the 5 to 3 brush to apply polyurethane to wood flooring edges and use the roller or pad to apply it to the center of the floor.

It s the actual curring of it which is done with special uv lights. Uv protection is another benefit of this flooring finish. Alternatives to refinishing engineered hardwood flooring there are steps you can take to delay the need for refinishing your engineered flooring. Whether you can seal a prefinished floor with polyurethane depends on your circumstances and the condition of the hardwood floor.

Maintenance costs and labor are reduced over the lifetime of the floor. When it comes to polyurethane you have two choices. Sweep the floor and then damp mop it with water and white vinegar 10 1 ratio or go over it with a tack cloth. If you want a rich color without having to reapply coats an oil based poly is your best bet.

Adding a layer of polyurethane sealer to the existing finish a process known as refreshing the finish is a good option when light wear that hasn t penetrated the wear layer is starting to show on your flooring. Hand sand corners edges and under cabinet kick plates. Engineered flooring is somewhat less expensive than solid hardwood but most types can be sanded and refinished only once since the surface hardwood layer is relatively thin.