Plunge Cut Hardwood Floor

Keep in mind the default blade that comes along with the saw won t work well for situations like this.

Plunge cut hardwood floor.

While multi tools are commonly used to cut holes in drywall for electrical boxes they can tackle any job that needs a plunge cut. Draw a line for the cut then use a. You want the new butt joint to be staggered about 10 in. While using the dust collection system little if any dust was expelled.

In any case keep in mind that heat kills blades. With hardwood floor repair you need to first determine what should be removed. Another situation where i found the saw effective was cutting up this hardwood floor for removal. A crosscut blade on the other hand is designed to produce a smooth cut across the grain of the wood without splintering or tearing.

It makes them easy if you use the right blade. A rip blade isn t designed to yield a mirror smooth cut but a good rip blade will move through hardwood with little effort and leave a clean cut with minimal scoring. Plunge the saw blade into the laminate. Look at the damaged flooring plank and decide how much length to remove.

If you have a scratch but you don t think the bamboo plank s needs replacing learn how to refinish bamboo flooring. A straight blade is best for plunge cuts where you stab the blade into the surface. The tool is designed for impossible plunge cuts. Plunge cuts are easy.

A miter saw is nice because all you need is a simple little mark and the saw will do the rest of the work this is the ideal tool and can cut perfect 90 degree cuts or any other angle up to 50 degrees for most saws. Step 1 mark the laminate flooring along the desired cut line by using a chalk line. For long linear cuts use a round oscillating saw blade. Cutting out and replacing damaged hardwood floor planks just takes a bit of elbow grease time and the right set of tools anyone can do it.

Using a miter saw. With the correct setup and tools cutting installed laminate flooring is not difficult and it looks good when completed. Repairs removing floors. Remove damaged planks once the new end seam is fully defined set a depth of 3 4 or the depth of your floor on a plunge saw or circular saw for a cleaner job a plunge saw with vacuum attachment is ideal.

You can use either a sliding model or a non sliding model just make sure the blade is large enough to cut the entire width of the laminate flooring in one pass. Festool cutting tool used to cut through damaged hardwood floor planks. You ll get cleaner cuts with the round blade if you make a shallow scoring cut first then gradually deepen it with an oscillating saw.